#ANY TO ISO 373 SERIAL KEY SOFTWARE#
#ANY TO ISO 373 SERIAL KEY SERIES#

In the USA and Canada, Magna-Power sells it products directly from the factory, with a nationwide network of technical representatives.

#ANY TO ISO 373 SERIAL KEY SERIES#

The current build-time for the TS Series is 6-7 weeks. Magna-Power products are made-to-order with build-times that vary depending on the model's maximum power rating.

Requests from this form will either be quoted directly or automatically routed to the appropriate sales partner for quote. Magna-Power products are available worldwide through direct sales offices and authorized distributors. In the USA and Canada, Magna-Power sells it products directly from the factory, with a North American network of technical representatives. 20/25 kW models with 208/240, 3О¦ input come in a 6U chassis. * Models marked with an asterisk are special low-voltage high-current models that may vary in size and input current from the standard TS Series models within the same power envelope. With the High Slew Rate Output (+HS) option equipped, high bandwidth operation is enabled along with fast rise times, allowing the MagnaDC programmable DC power supplies to address requirements for Hardware-in-the-Loop (HIL). The following list summarizes the available I/O from the power supply:

All these pins are isolated from the output terminals and referenced to earth-ground as standard-no additional isolation equipment or options necessary. Reference +5V and +10V signals are provided, eliminating the need for external voltage signals and allowing the use of dry contacts.ДЄlso, the power supply features a normally closed external interlock, which when enabled, allows the power supply to be tied in with other emergency stop equipment. Each diagnostic condition is given a designated pin, which reads +5V when high. The voltage, current, over voltage and over current set points are set by applying a 0-10V analog signal. Using the rear isolated 37-pin I/O connector, included as standard, the MagnaDC programmable power supplies can be completely controlled and monitored using external signals.

#ANY TO ISO 373 SERIAL KEY SOFTWARE#

The included Remote Interface software supports RS232, LXI TCP/IP Ethernet, and IEEE-488, along with the USB and RS485 converters. Emulate non-linear profiles, such as solar arrays, pseudo-resistance for N+1 redundancy without wires, or automatic compensation for leadless remote sensing. Recalibrate internal digital potentiometers. Quickly get the status of all the power supply registers from one screen. Explore all the available commands, along with logs of what string the software is sending to the power supply used for developing your own software. Use a virtual front panel on the desktop to remote control the power supply from a computer. The Remote Interface Software has six different windows, including: The software provides the user with an easy and intuitive method to operate a Magna-Power Electronics power supply with computer control. In addition to being able to develop your own software, Magna-Power's Remote Interface Software is also included with all power supplies. In addition, the support SCPI command set provides an easy to use API using ASCII commands over any interface. All MagnaDC programmable DC power supplies come standard with National Instruments LabVIEW and IVI drivers.

Any to iso 373 serial key